SigP228 hammer bug
-
- Posts: 76
- Joined: Wed Mar 30, 2011 6:21 pm
- Contact:
SigP228 hammer bug
On the sig p228, if you remove the hammer before you remove the slide, the hammer will snap back to the gun when you remove the slide.
- Stronger
- DevTeam
- Posts: 1638
- Joined: Wed Mar 30, 2011 2:28 pm
- Contact:
Re: SigP228 hammer bug
Can you post screen ..It is impossible to remove the hammer before remove the slide!
-
- Posts: 76
- Joined: Wed Mar 30, 2011 6:21 pm
- Contact:
Re: SigP228 hammer bug
You would think... but, you can remove the grips, the mainspring, then the hammer pin, the hammer itself, and quite a bit more without pulling the slide first
but once you remove the slide, the mainspring/hammer snap back into position and cant be removed again without restarting!
here is a before and after
but once you remove the slide, the mainspring/hammer snap back into position and cant be removed again without restarting!
here is a before and after
- Stronger
- DevTeam
- Posts: 1638
- Joined: Wed Mar 30, 2011 2:28 pm
- Contact:
Re: SigP228 hammer bug
Thank you...I fixed it
Who is online
Users browsing this forum: No registered users and 14 guests